Waldorf FNL8130G Specifikace

Procházejte online nebo si stáhněte Specifikace pro Hluboké fritézy Waldorf FNL8130G. Waldorf FNL8130G Specifications Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 35
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
Installation and Operation Manual
‘Fast-Fri’ Gas Fryer
FN8120G
FN8226G
FN8130G
Date Purchased
Serial Number
Dealer
Service Provider
228573-16
For use in GB
FNL8120G
FNL8226G
FNL8130G
Zobrazit stránku 0
1 2 3 4 5 6 ... 34 35

Shrnutí obsahu

Strany 1 - ‘Fast-Fri’ Gas Fryer

Installation and Operation Manual ‘Fast-Fri’ Gas Fryer FN8120G FN8226G FN8130G Date Purchased Serial Number Dealer Service Provider 228573-16 Fo

Strany 2

8 Installation Location 1. This appliance must be installed in a suitably ventilated room to prevent dangerous build up of combustion products. 2. I

Strany 3 - Contents

9 Fitting Rear Rollers. 1. Raise the appliance from the floor by approx. 75 mm using suitable lifting equipment (i.e. Palletiser / Forklift) to allow

Strany 4 - Introduction

10 Gas Connection NOTE: ALL GAS FITTING MUST ONLY BE CARRIED OUT BY A QUALIFIED SERVICE PERSON. 1. Waldorf Fryers do not require an electrical conn

Strany 5 - Specifications

11 10. Light the Main Burners. Refer to the ‘Operation’ section, ‘Lighting the Main Burners’. 11. Verify that the supply pressure is still correct.

Strany 6

12 Operation Operation Guide 1. WALDORF 'FAST-FRI' Gas Fryers have been designed to provide simplicity of operation and 100% safety protec

Strany 7 - Dimensions

13 Operation Twin Tank FN8226G Controls Thermostat Control Knobs for each Tank Fig 4 Single Tank FN8130G Controls Left & Right Piezo Igniters Ga

Strany 8

14 Operation Before Use 1. Check that the gas supply is turned ‘On’. 2. Check that no foreign articles are in the tank. Filling the Tank(s)

Strany 9

15 i. Pre-Heating; Light the main burners and manually cycle the burners ‘On’ / ‘Off’ until the shortening has liquefied. Ideally the main burners s

Strany 10 - Installation

16 Lighting the Main Burners 1. Ensure that the pilot burners are alight, by opening the front access door of the appliance and checking that both pi

Strany 11

17 Frying Guide and Care of Frying Oils and Fats. 1. Prepare the food correctly. Prepare the food in as nearly uniform pieces as possible and bring

Strany 12

The reproduction or copying of any part of this manual by any means whatsoever is strictly forbidden unless authorized previously in writing by the ma

Strany 13 - Serial Number of Unit

18 Operation Smoking Temperatures of Frying Mediums. Based on work by the American Meat Institute. Frying Temperature Chart This chart is intended as

Strany 14 - Operation

19 General • To achieve the best results cleaning must be regular and thorough and all controls and mechanical parts checked and adjusted periodicall

Strany 15

20 Daily Cleaning 1. At the end of each day or at the end of each shift, if the frying schedule is heavy, the frying medium should be drained and fi

Strany 16

21 Weekly Cleaning NOTE: If the fryer usage is very high, we recommend that the weekly cleaning procedure is carried out on a more frequent basis. 1

Strany 17

22 Fault Possible Cause Remedy Frying medium foaming. Presence of soap or detergent residue from cleaning the tank. Rinse the fryer thoroughly thre

Strany 18

23 Fault Possible Cause Remedy Rapid oil breakdown. Inadequate frying oil turnover. Adjust procedures to fry more food in the fryer to increase th

Strany 19

24 Fault Finding Fault Possible Cause Remedy Pilot Burners will not light / stay alight. Check gas supply is turned on. Turn on gas supply. Check g

Strany 20

25 Fault Finding Fault Possible Cause Remedy Over temperature Thermostat cuts out the Pilot Burners. Overtemperature thermostat is faulty. If thermo

Strany 21 - Cleaning and Maintenance

26 Wiring Schematics FN8120G / FNL8120G Fryer - Single Tank TP THTHERMOSTATOVER TEMPTHTPIGNITIONTHERMOPILEL.H. PILOTT/CR.H. PILOTCROSS LIGHTINGT/CFLAM

Strany 22

27 Wiring Schematics FN8226G / FNL8226G Fryer - Double Tank THTP THTPMAIN GAS CONTROLSIT NOVA 820mVMAIN GAS CONTROLSIT NOVA 820mVPILOT PILOTT/CTHERMOP

Strany 23

1 Contents FN(L)8120G ‘FAST FRI’ GAS FRYER (Single Tank - 20 Ltr) FN(L)8226G ‘FAST FRI’ GAS FRYER (Twin Tank - 26 Ltr) FN(L)8130G ‘FAST FRI’ GAS F

Strany 24 - Fault Finding

28 Gas Conversion and Specifications Conversion Procedure NOTE: • These conversions should only be carried out by qualified service persons. All co

Strany 25

29 Gas Conversion and Specifications Pilot Burner Injectors 1. Unscrew the pilot supply tube from the pilot burner fitted to the mounting bracket and

Strany 26

30 Gas Conversion and Specifications Gas Type Identification Label On completion of the gas conversion, replace the gas type identification label loca

Strany 27

31 Replacement Parts List Replacement Parts List When ordering spare parts, please quote the part number and the description as listed below. If the

Strany 28 - Wiring Schematics

32 Replacement Parts List Gas Conversion Kits Accessories (Optional) 228793 450 mm (Fryer) Plinth Kit. 228794 600 mm (Fryer) Plinth Kit. Model Gas

Strany 30 - Conversion Procedure

We are confident that you will be delighted with your Waldorf 'Fast Fri' Gas Fryer, and it will become a most valued appliance in your comme

Strany 31

3 Specifications Model Numbers Covered in this Specification FN[1]8120G ‘FAST FRI’ GAS FRYER (Single Tank - 20 Ltr) FN[1]8226G ‘FAST FRI’ GAS FRYER

Strany 32 - Gas Specifications

4 Gas Connection Non UK Models only: FN(L)8120G Gas supply connection point is located 151 mm from the left hand side, 36 mm from the rear and 124 m

Strany 33 - Replacement Parts List

5 Dimensions FN(L)8120G FN(L)8226G

Strany 34

6 Dimensions FN(L)8130G

Strany 35

7 Installation Installation Requirements NOTE: • It is most important that this appliance is installed correctly and that operation is correct before

Komentáře k této Příručce

Žádné komentáře